![]() I have better results with lower flow rates (dia 0.4 or 1900%), but more testing needs to be done. Filament diameters of around 0.38 translate to the 2200% cmeyer posted (flow rate factors in quadratic, so use fine steps when adjusting it). Flow rate percentage adjustments mess up the ‘layer view’ in Cura (from years of experience with an Ultimaker 2, I find this one of the most helpful features in Cura). Keep in mind that you may have to find a physical solution for levelling the build bed when using Cura.ĭ) With the current version of Cura (v3.3.1) it is better to adjust the flow rate of molten filament via the filament diameter, than the flow rate percentage. It offers a build volume of 180 × 180 × 180 mm. It uses the Fused Filament Fabrication technology to produce thermoplastics parts using filament feedstock. ![]() The nozzle is too far away from the bed, if the individual lines can be easily separated and do not stick together.)Ĭ) Up Studio allows for an 9-point calibration routine for the z-axis. The 3D printer is a 3D printer produced by Cetus3D, a manufacturer based in China. Either attach a new jst connector to the 60mm blower fan or use the one from the 40mm fan using the scotchlok connectors. The nozzle is too close to the bed, if the brim thickness (z-direction) gets to thin and translucent. Installation Remove the existing 40mm fan and cooling duct and clean up as needed. If you use a brim around a test-model in Cura, the correct height is achieved, if the individual lines that make up the brim squash together nicely. (I think a painfully precise calibration is overkill. ![]() I did compile my ‘own version’ from the start code by chrisevich. Perhaps the info below will help someone in the future:Ī) I used the start and end code from chrisevich ( #11) which worked nicely for me.ī) the z-axis calibration code posted by cmeyer never worked for me. I just wanted to thank everyone who contributed to this thread - it helped me tremendously when setting up my Cetus3D MkII with Cura. The downside to this printer is that the firmware on the. Also the quality of the build and hardware components is quite good, featuring linear rails and a 32bit cpu. G1 X50 E360 F300 extrude a 5cm purge line Its small and affordable (although not on the super cheap range of the Chinese printers). in the machine settings I've set all the print-head settings to 0, haven't experimented with that. in the machine settings set your nozzle size. G1 X2 Y178 F5000 move to back right corner To set up Cura: - Add a Custom FDM Printer (name it Cetus) - in the machine settings set widthxdepthxheight as 180x180x180. M206 X-180 offset X axis so the coordinates are 0.180, normally they are -180.0 Do the paper test and use a gcode file something like this:p.p1 the nozzle offset may be different than in Cetus Studio. make sure your nozzle offset is correct in the starting g-code
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |